Moulding Silicone on Platinum Catalyst (hardness 20 ShA)
M-20
20,00
€
€
Add to cart
Two-component platinum-based silicone rubber. Hardening at room temperature. Exceptional fluidity, convenience and ease of use, easy demoulding. Good tensile, elasticity, tear strength, no shrinkage. High replicability and durability of operation. Retail prices are indicated! For information on wholesale prices, please contact the seller! Moulding Silicone on Platinum Catalyst 20 ShA. GENERAL DESCRIPTION: Two-component platinum-based silicone rubber. Hardening at room temperature. Exceptional fluidity, convenience and ease of use, easy demoulding. Good tensile, elasticity, tear strength, no shrinkage. High replicability and durability of operation. Used for moulding of polyurethanes, polyester resins, plaster, wax, paraffin, gypsum, concrete, liquid plastics, soaps. For the production of souvenir products, sculptures, figurines and other handicrafts. RECOMMENDATIONS: Mechanical as well as manual mixing is acceptable. Make sure the compound has a room temperature before mixing the components. Keep in mind that when storing (or transporting) material outdoors in cold weather, it may take up to 24 hours for the components to reach room temperature. The optimum room temperature during moulding should be 20-25 °C, and the humidity should not exceed 50%. Use a clean and dry container to mix the components. Mix the mixture thoroughly for 2-3 minutes, periodically scrubbing from the sides and bottom of the container. TECHNICAL SPECIFICATIONS Brand - 20 Colour – semitransparent Ratio of components A: B-1: 1 Pot life (min at 25 ℃) - 20 Polymerization time (hours at 25 ℃) - 16 Shore hardness (A°) - 20 Density (g/cm 3) - 1.08 Viscosity (CS -25 ℃) component A - 30000 ± 5000 Viscosity (CS-25 ℃) component B - 5000 ± 500 Viscosity (CS -25 ℃) after mixing - 10000 ± 2000 Tensile strength (kgf/cm2) - ≥90 Tear resistance (kgf/cm) - ≥20 Elongation at break (%) - ≥ 430 Linear shrinkage (%) - ≤0.1